The reviews are automatic translation.
Screw tightening in the impact driver
On 2016-11-18 17:05:22
Always use this bit of impact drivers use
Although there is be damaged too much tightening, it has become a necessity because it is not possible to become unusable cutting edge until this is exhausted
On 2016-03-11 18:37:30
It was used in the impact driver of Makita, but the tip of the bit it was difficult licked so you bite into the tightly screw thread.
However, whether the compatibility of the screw was bad, it will feel stuck a bit of tip you do not do when the screw mountain to draw a little after you have finished out the screws.
Well, But I will take immediately.
It would be evidence that jagged has caught a screw kit.
Now it is the most favorite because so so easy to cheap to use.
In tap repair
On 2016-03-03 12:18:57
Well easy to use with eating.
Since the neighborhood hardware store has less variation,
Without going to buy it has helped us choose a lot.
Bit of classic
On 2015-12-15 16:07:55
Work efficiency than ordinary bit will go up because there is good with eating jagged.
On 2013-12-15 15:58:27
But I only use it every time.
Biting is good think.
On 2013-04-22 15:29:10
I have used various bits, but this bit does not come out the most. However, it breaks from scraping off prevention of coming out. But even if you deduct it, this bit is the best to use.
Home electronics, car repair
On 2011-08-07 21:27:07
Bottom: Bessel is the best in domestic drivers.
When using the impact of the work using 2 by 4 materials
On 2010-10-01 16:46:45
I use an impact driver with AC 100V. It is easier to come out because the revolution speed is faster than the battery type, I love kore. Even Giza Bit can not completely eliminate the cam out, but it is completely useless because it is completely useless with other bits. Compared to other bits, it is excellent, so I'd like to say "satisfied", but since coming out still happens, I decided to be "somewhat satisfied". But it is a good product.
Screw tightening with impact
On 2009-06-18 22:40:10
Since it screws well and the screw head is not slippery, it can be used safely even on makeup surfaces. However, it is not easy to break because it is not easy to break.
On 2009-02-24 18:42:22
Basically, hand tool is used, but rarely use impact. Since the cutting edge is a Giza blade, it digs well so it is hard to crush the thread mountainily! Perhaps Bessel is the best for use with domestic screws.