The reviews are automatic translation.
On 2016-08-04 10:16:59
Extent that I thought is to not shaved, become useless and use once.
Removal of broken 4M tap
On 2016-06-15 19:51:11
To work start after two minutes to set the milling machine, it has broken at from the tip of the 5mm position. You might be well drilling depending on the conditions, but as the foundation unreasonable work in the amateur. orz that it took nearly half a day to recover from this sense of frustration.
Battery-powered electric drill use
On 2016-04-27 14:49:06
It has is certainly scraped, but about 6mm its speed is doing very slow 3 hours.
Drill I have broken from the middle of them.
Perhaps way was bad, but not convinced.
Drilling in hard shaft
On 2015-10-29 15:59:54
Used in a 3 mm drilling in carbon steel shaft it was impossible in the drill.
The amateur use accompanied by trial and error, had been missing teeth through just before. . Kana heal in polishing ,,
In the electric hand drill there is a risk of missing teeth, but impose slowly over time point or with.
Removal of damaged tap
On 2014-10-31 09:03:52
M6 tap made of OSG that broke accidentally
Whether it is to be able to make a hole in the hard drill of the same manufacturer?
Moreover, the tap is broken while the stuck near 20 mm.
Honest story, did not expect ...
In fine movement feed milling, gingerly start the feed
In dry cutting, it opened the through-hole of depth 20mm to M6 tap!
Moreover, it was withdrawn in the thread intact!
Exactly "spear and shield" complete victory!
Amazing'll this drill!
OSG is not a Date ♪
Removal of damaged tap
On 2014-08-24 16:30:36
You should buy this product from the beginning,
Nothing this was to waste the blade of the drill.
Removal of broken taps
On 2014-05-12 16:32:08
Quite time to cutting took, but we were able to remove the safely tap.
Drilling of carbide plate
On 2014-03-24 14:09:04
Sharpness sounds good. However, the total length is the best if 50mm.
If the total length of more than 50mm in other brand item, please introduce.
Broken tap removal
On 2013-06-27 17:08:45
It would Fold the tap, but hesitated and carbide drills to remove, buy here in horses for courses
Because you work in a drilling machine, I have a little, remove the core, but we managed to remove
I'd better not next time, but when of emergency would try to use the milling machine
As MonotaRO TIN-I-SFT M6x1 Tin Court spiral tap broken tap for removal
On 2012-05-18 00:43:05
The cutting conditions were confirmed by OSG HP, but because you do not know, the main spindle rotation speed of 1,800 rotation in the interim, gave a dry cutting. First of all, a broken tap part with a diamond grindstone, after almost flat, but was cut to breakage tap part by reducing the feed of the hard drill, enough of all, does not turn off. Difference in hardness between the spiral tap did not almost feel.
After all, we have abandoned the broken tap removal in the middle. ⇒ work by milling machine
On how to use the manufacturer's would be appreciated inquiry whether there is an error.