The reviews are automatic translation.
On 2016-07-26 17:25:14
It is very may use. It is GOOD.
On 2016-05-31 14:43:18
None in particular impossible without also acceptable
When the hobby of need is tapped at the time of processing of mechanical parts, it will be used to tap fresh from time to time
On 2016-05-03 19:22:01
I have previously purchased a hand tap (those that are not spiral tap), the case of deep tap, resistance is broken, such as the bad big, so could not be satisfied, but the manufacturer was also different, this time in the spiral tap I saw, but it is used in the feeling and Yu Well usually kana.
Threading of the resin moldings
On 2015-11-18 15:06:57
Burr comes out a lot in a reciprocating working with Tupperware.
Loose screw of the finished than the previous purchase.
On 2015-10-15 17:12:35
Since the manufacturer goods is up to the change without stable comfortable to use now.
On 2015-03-30 10:20:56
I ordered to cut the M8 screws. Character of MADE IN KOREA tried to cut the screw to try in the mood. What a person can not go is went into the Nejigeji is I have also contains 2 around.
So I noticed OH standard look into the points again this tap.
Purchase goods OH2, it was discovered because OH3 of the price is slightly higher under it. Maybe screw gauge that it is here was I think not fall only about half around. But it was expected because there was a "Returns accepted" by things, I unreasonable like because it does not write. Note that you use any time of the product of the company standard is not noisy in. Recently parent company is especially noisy, it can not be used in the bottom of the product. I have harmed in the just Tsu 100 yen stingy. Three buy, a single use. (Do not hear the exchange at the very least, even only two?)
Also it is said OH standard or the like to the ordinary can manufacturing company will in trouble.
Bag nut production
On 2015-03-14 18:36:31
Sharpness is good, it has been used without any particular problem.
Chips are, you will be saved because out on top.
Play of screws rusted
On 2014-07-07 20:45:37
I used playback of sputtering up rusted screws of welding, but we are satisfied well is very bite
Tapping of SUS material
On 2014-06-13 13:27:57
Yaketsuki, it is less broken loss tap.
Especially recommended to the SUS material.
Tap oil is even better and use the paste instead of the spray.
On 2013-08-17 10:07:28
It was good because was able to purchase a tap of the hard-to-use diameter and pitch (M30P1.5). Straight collet to use the tap (Φ23) also purchased here. Is set to NC milling, but we used to S50C was able to tap processing normally.