The reviews are automatic translation.
The camera can be built towards the hobby! !
On 2017-01-22 20:04:32
Since the pan head of the screw of the camera is this
Various and spread the idea and this is in the time to make such little attachment, such as in a timber of aluminum at the camera platform.
Rebuilding of the tap
On 2016-05-15 08:15:03
Inch tap immediately enters the hand, I am very satisfied.
Modification of the screw groove
On 2015-02-04 13:10:40
Work with excellent sharpness is easy.
Speaking by force, characteristic processing of blind holes of the product? In, it was not able to work and not open the pilot hole than necessary it was regrettable.
Commodity explanation, it was hard to what understand to people not in the profession of cutting.
As the fabrication of ultra-small steam engine each part
On 2014-11-19 19:04:39
If so inches of thin tap the size you to the freshly screws paying close attention, such as a plane that can penetrate does not occur most Orekomi sharp and crisp, but the bend or there is a wall in the place where hits the tap tip thin tap if the tap can not be through there is a place a little more want the strength of the tip because without focusing easily Orekomi occurs.
Modification of inch of bolt thread
On 2014-02-07 06:40:47
I was able to safely fixed in thanks.
Modification of rusty screws mountain
On 2013-11-11 12:49:18
It was good because I did not find a tap of the 24 mountains of inch size.
Sharpness is preeminent.
On 2012-09-04 16:27:02
The sharpness is good when new. Life is slightly short, but there is no problem from the price.
Repair of scaffolding hardware
On 2012-05-02 21:59:05
The feeling of use of the tap is normal. I think that the good point of the monotaur is in the place where it is inexpensive and you can buy a product that is difficult to purchase at a general store.
On 2012-02-17 17:09:01
It is convenient to use ~
Threading of grease nipple for bearing unit
On 2011-11-22 17:33:00
This tap was saved because screw pitch is unusual.