The reviews are automatic translation.
Rebuilding of the tap
On 2016-05-15 08:15:03
Inch tap immediately enters the hand, I am very satisfied.
Modification of the screw groove
On 2015-02-04 13:10:40
Work with excellent sharpness is easy.
Speaking by force, characteristic processing of blind holes of the product? In, it was not able to work and not open the pilot hole than necessary it was regrettable.
Commodity explanation, it was hard to what understand to people not in the profession of cutting.
As the fabrication of ultra-small steam engine each part
On 2014-11-19 19:04:39
If so inches of thin tap the size you to the freshly screws paying close attention, such as a plane that can penetrate does not occur most Orekomi sharp and crisp, but the bend or there is a wall in the place where hits the tap tip thin tap if the tap can not be through there is a place a little more want the strength of the tip because without focusing easily Orekomi occurs.
Modification of inch of bolt thread
On 2014-02-07 06:40:47
I was able to safely fixed in thanks.
Modification of rusty screws mountain
On 2013-11-11 12:49:18
It was good because I did not find a tap of the 24 mountains of inch size.
Sharpness is preeminent.
On 2012-09-04 16:27:02
When new the sharpness is good. Some life, but is short, no problem and from the price.
Repair of scaffolding bracket
On 2012-05-02 21:59:05
A feeling of use of the tap is normal. Good point of Monotarou general of hard to buy in the store products I think that in the place where you can buy inexpensive.
Modification of the nut
On 2012-02-17 17:09:01
Ease of use is good -
Screw processing of the bearing unit for grease nipple
On 2011-11-22 17:33:00
The tap was saved because the pitch of the screw is rare.
US equipment is a lot inch screws, inadvertently JIS and, you use the shuffle again when you accidentally screwed Standard pitch.
Well do the will, 5/16 fine pitch, 1/4 fine pitch, I think that it will need in the future.
On 2011-09-08 14:19:28
It can be used without any problems in this product.
Rather than make a tap in the new in my case, for modification of the screw holes Tsu Flip acrid purposes, further I think big things are better of play in the No. 1 tap.