The reviews are automatic translation.
On 2017-03-06 17:20:47
Used for threading of stainless steel. There is no whatsoever of dissatisfaction.
Tapping of stainless
On 2016-07-14 17:43:03
Even somewhat higher price chose the confidence of the product. Because it is useless it is got broken in the middle.
Tapping of iron plate
On 2016-02-08 16:07:16
Because for the SUS, stop the tap gauge side got through. Because it was not loudly work, it was used to life.
On 2015-12-27 12:50:09
Purchase to make a thread in thick iron plate, I went off to a break that without Don Don mountain because originally a stainless.
Open the small holes of the radio-controlled parts
On 2015-07-27 07:43:07
Was used in the 2mm threaded of trying to own the aluminum servo horn, it was the tip may break jam for the second time cutting screws. Recovery you try to re-open is entirely fails, does not become useless after all. Because aluminum is a fixed to the cutting edge, but the mini-milling machine proceeded cut to avoid adding carefully excessive force in the hand-cranked while dropping the cutting oil, bought a tap of the increase in order to cover their own immature degree also I'm sorry for this result.
Use the landslide of the nut
On 2015-04-16 18:42:51
Well it is sharpening.
On 2015-04-08 15:36:46
We are using the same or higher of the commodity in the repeat.
Tapping of sus material
On 2015-03-19 18:01:18
Nice place of tap of OSG is ideal for tapping of the through-type because the chips fall down.
Tapping in the machining center
On 2014-09-17 20:53:28
Well cut, durability is also a so-so, we are satisfied.
On 2014-09-06 10:00:44
When the control panel assembly. Kana good