The reviews are automatic translation.
Drilling for through wiring sash
On 2016-12-13 14:51:01
It was used for the drilling of the bag-shaped aluminum sash, but, although the penetration from the front side there is no problem, did not cut easily when an attempt is made directly through.
I think the sharpness itself is no problem.
Since it attached to the impact drill or the like, convenient.
Using the aluminum cans of canned beer and coffee, it is to build the now-large trendy alcohol stove.
On 2016-11-24 15:37:58
It is required to hollowing out the order of 32 mm in order to successfully release the fuel from aluminum cans. In hollowing out the degree of aluminum cans, cutting oil whats answer from the manufacturer that there is no need.
In order to hollowing out round with the bottom of the cans of canned beer, the hole saw is the necessities.
Without cutting oil, you can make room To smoothly. Finish is also beautiful. Also it creates a lot of alcohol stove product now. It is fun every day.
Vacuum tube amplifier production
On 2016-10-17 19:23:39
Hole saw of thin blade was used for the first time.
Purchased a 24mm, it was the a hole in the drilling machine.
I thought something there will be a 24mm hole in it actually opened a hole of 24.4mm.
When the outer periphery of the tooth try measured in vernier caliper, it has up to 24.3mm and the variation from the minimum 23.8mm.
Thin blade type of hole saw, but was purchased for the first time, do you such things?
For tight dimensions it was not where needed, I think tries to continue to use, but be availabe in a large? You might be better had been thought.
Drilling of stainless steel top plate (sink)
On 2016-09-29 17:18:29
It was anxiety in appearance, such as rounding a thin iron plate, but it did open a clean hole in the stainless steel plate of about 1mm. Chipping of the tooth is also without First satisfaction.
The drilling of the table
On 2016-08-03 14:48:07
Cheaper price than home improvement.
Drilling heavyweight rubber
On 2016-04-08 15:20:43
Hard to take out of chips. The smaller diameter product center axis even thin more is desired.
You will not in addition to the perforation.
On 2016-02-10 00:46:48
Stainless steel is also cut crisp.
On 2016-02-10 00:21:14
Challenge to the stainless steel 1,5mm. With the cutting paste, it has expired comfortably in the low-speed mode. It has several drilling, but no sign of sharpness becomes worse. We do not need the expensive Holsoe of stainless steel only. It was repeater in ....
Aluminum die-cast case drilling plate thickness 3mm
On 2016-01-04 23:16:31
Without stress can drilling of this diameter. I think that it is a very good product.
Blurring of the tooth without any, there was no excessive force is also necessary.
Customization of automotive
On 2015-12-09 15:56:26
It must make a hole in such wiring work, specified were purchased from this line-up since the 11 Miri