The reviews are automatic translation.
On 2017-03-24 18:16:33
There is no problem. In addition, it purchases if necessary.
Tap hole in the control panel in the plate
On 2017-02-28 11:13:50
I was using the OSG, but this tap is useless for break immediately caught. I'm worried because although I do a pilot hole from 3.3 to 3.4 there is only 1.6 iron plate. It was purchased what this either, but it was another of the same.
For no such thing like that in the case of OSG.
Processing of precision parts
On 2015-08-28 14:40:10
During small-diameter screw standing work, I often taste the tears of tap breaking. For inexperienced metalworking, the low price of this product is the salvation at least.
When tapping products
On 2015-04-23 14:58:15
Although it seems to be somewhat impossible to cut, price is a little cheap, so well, COSPA is subtle.
With set refill!
On 2015-02-20 13:57:22
I broke up during work the other day and got it by supplement.
Tap cutting of woodworking
On 2014-02-04 13:29:23
For this size, if it is hard wood, you can make a firm tap with wood. You can save the ogre if it is an application that does not require drawing power.
Drilling tap work
On 2013-12-22 13:16:39
Tap work can be done normally. Although it is a consumable item, we will decide on durability from now.
Tap of steel material.
On 2013-12-04 14:03:13
It is good for SS and SK material, but there are some durability when it is hard material such as SKD, DC 53 etc. Because other taps are so, I will only do this review.
Plain penetration tap up to t12 mm
On 2013-10-28 09:41:56
With a radial board, I think that it is very good if it is up to 12 mm with plain board, I broke it if it was t25, I use it properly.
General steel thread cutting
On 2013-10-01 08:16:27
The cut is good. Do you own it normally?