There is also stainless steel or heat-treated metal that cannot be stamed
Holder is not suited for other stamps.
Stamp: HRC40, electrode-holder:HRC50
ALPHABETIC CHARACTERS (A-Z) x TWO EACH, DIGIT (1-9) X TWO EACH, NUMBERS (0) x 3, SPACER () x 3, POINTS (.) x 1, SLASH (/) x 1 , and (&) x 1, MINUS (-) x 1, HOLDER (FOR 5 letters) x fixed wrench x 1, extension plate x 1
Marking on metal products Attached to a self-made jig and stamped with a press machine
On 2011-11-10 00:24:03
Distribution of numbers, letters, etc was the best. If ordinary 2 sets necessary place I was worried about the variation in width and height because it was made in Taiwan made in this set, but it was uniform uniformly. It is regrettable that there is only a character height of 5 mm. Please release 3 mm version by all means. Since it is also expensive, please consider rose selling as well. I think that it is convenient to put out the things necessary for engraving if you make it a double bottom so that the sponge part which will be engraved at the end is made