The reviews are automatic translation.
French car maintenance
On 2017-05-17 14:40:49
This size is saved because it is not used in Japan. It is used for correcting the nut and screw fixing the aluminum case
On 2017-05-12 10:56:42
OSG's tap is good with sharpness, I always use it. The price is relatively high, it is a place I always suffer.
Replenishment of missing parts
On 2017-04-12 15:48:03
The usability is better than I thought, the screw was torn off pleasantly.
Tapping to the machine
On 2016-10-23 21:52:12
No problem at made OSG of peace of mind to work at this price.
Threading of production processed goods.
On 2014-05-31 11:49:32
Since the amount of money is cheap, I think it would sharpness becomes worse, three to prepare, but was threaded processing, until the end (about 300 holes) processing ends with a single tap.
Sharpness may be, work quickly to an end, was saved. Next I would also like to use the tap of this manufacturer.
Hand tap work
On 2013-01-03 12:37:49
Accuracy, can be used without problems in finishing state both.
Hand processing of aluminum die-casting
On 2012-07-28 15:42:09
I was worried because the thin screw, but it did make a catchy and threads.
On 2011-01-18 14:23:54
Even cheap, it can be used normally,
Field of hobbies
On 2010-12-23 07:39:29
Fixing chips on byte carpenter mini lathes into bytes
On 2010-12-08 20:46:53
The barely sold the screw but the tap set Φ 3.5 mm pitch 0.6 mm is not special I think that it is a special size Objective is satisfactory enough satisfactory