The reviews are automatic translation.
On 2017-07-26 16:21:15
Actually I wanted about # 100, but since this is the only one I bought.
Chamfering and deburring of steel
On 2016-04-02 16:37:59
On 2015-11-28 16:46:44
It is good.
Rough correction of the missing saw blade etc.
On 2015-07-22 19:29:12
We use it to correct the missing blade such as a circular saw by scraping the tip a little like a taper. Compared to other manufacturer's grinding wheels, when cutting saw blades a little, it is slightly decreasing, but since there is no problem with grinding, it is planned to purchase continuously. I would like to purchase if there are things that are thinner and harder (outer size 255 mm, thickness 9.5 mm - 10 mm, degree of connection N) if you have nothing particular about the grindstones.
On 2015-05-16 17:23:06
I did not know that until purchase it was made by Crayonton's overseas factory. At the work site, I also gave an opinion that the outer diameter becomes smaller than the previous ones and it becomes impossible to use immediately if I dress it. However, I am satisfied that the use feeling of the product itself is good and I do not complain from the site. If possible, we would appreciate it if you can also make products with the same outside diameter as before.
Used in a grinder
On 2015-03-09 09:36:25
Since it is a maker item, it was possible to use it without purchase problem.
On 2014-05-02 19:09:12
I hope that it is a monotaro brand, more cheap.
Using a circular part to polish the spring
On 2014-01-30 18:04:16
I hoped for peelable glue the other day. The area of the paste was very small for the orders this time. Did it correspond quickly? Thank you very much.
It is used to polish the spring using the circular part.
On 2013-12-10 10:21:43
In order to use a wide surface, I remove the label, but it is difficult to peel off, so I'd like to change it to a glue that can be easily peeled off.
When you make a drill with a tooth missing or a tip of a scribe bar
On 2011-11-14 12:19:57
The feeling I used is smooth, and the teeth of a thin drill of about 4 mm can also be cleaned beautifully. We mainly use 3.2 mm - 16 mm drills, but we are satisfied as we can make all drill teeth with this grindstone.