The reviews are automatic translation.
When super finished canna blade is adjusted
On 2017-04-30 22:14:40
The magnet part is very stable and easy to use. Since the object to be measured is 30 to 40 microns, it is understood that precision does not occur in fine feed, and it is currently in use by removing fine feed. If there is description of the limit of fine movement feed in the product introduction column I think that I bought a base with no wasteful fine movement.
Mounting of the dial gauge
On 2015-10-25 21:19:19
It is good to be able to select a shaft.
The choice of length.
Out swing of lathe work
On 2015-10-23 14:40:30
Part of fine-tuning the strength is weak, could not use decent. It was replaced in addition to the round bar that was there in the factory.
Installation on dial gauge mounting machine
On 2015-04-10 13:50:33
Satisfied with low price. Desire speaks the attraction force of the magnet base is weak.
I'm wearing a dial gauge
On 2015-03-26 18:31:07
The fine feed is very convenient. There is no big difference in existence.
On 2015-03-09 10:06:09
There. However, although I used a pick tester and used it, fine movement is not very useful. It is good to use it considering it as usable at an approximate adjustment level.
Measuring work of shafts
On 2014-12-19 00:22:49
I feel the magnet is somewhat weak. I feel that the rigidity of the arm is also weak. Even if the main struts are tightened strongly, they loosen so quickly that screw lock is necessary
Fixing the sensor during testing
On 2014-09-16 14:19:55
Rigidity is also firm and easy to use.
Work such as milling machine
On 2014-02-12 22:15:07
I think it would be appreciated if there is more strength. I hope there is more freedom of movement.
Product shake inspection.
On 2013-07-29 08:06:40
Magnet can also perform powerful and stable measurement, and it can also be fine-tuned easily, so it is very convenient for product shake inspection, machine setup and so on.