The reviews are automatic translation.
It is for replacement for repair.
On 2017-04-11 11:25:25
It was nice to buy it very easy to use. It is amazing.
Production line feed belt
On 2016-06-08 07:34:58
There is no problem.
On 2016-02-26 10:56:26
Once upon a time is not in recently to have been in the box. But orientation was written at the time of storage in a box. Even with the new article would suspect new is.
Gear of YKK of up gate
On 2015-05-22 09:55:40
One shot OK replacement
Feed milling machine automatic
On 2014-11-08 12:43:48
Backlash is large, not suitable for automatic feed.
As a milling machine automatic feed power.
On 2014-10-14 10:28:51
Little, accuracy is high satisfaction backlash.
On 2014-05-20 13:57:05
For the shifting of the industrial machine of the driving motor
On 2013-06-29 19:50:53
Previously it used to have the motor, but it was a M6RA6G4Y + gearhead MA6G50B now out of print, and seems M6RX6G4Y can be used as a compatible
Fit to M6RX6G4Y, it was replaced in this gearhead (MX6G50B)
At this rate it could not be used.
Projection of the gear mounting part is, you need to scrape off longer than MA6G50B, at the same
Because it does not work with the cut of the screwed portion of the projections of the gear attachment portion is shallow there is also not scraped
From M6RA6G4Y (motor), in the case of exchange of compatible You had better be careful.
Workaround if the margin in the way or motor top of scraping of the above there, it might be good to put a spacer, etc. between the machine and the gear head.
Us, we use to put a spacer.
To work, rotate the scissors grinding stone. I'm sharpening sharpener specialized sharpener.
On 2010-06-22 08:37:40
I am using it with the G8 motor of the M81 X 25 G 4 L "Tsui". Without this you can not sharpen. If you do not have a gaud head, you work with a blade with a motor of 1550 revolutions per minute that does not have a blade, it gets hot and gold will rise. So, drop the rotation to 500 rpm and attach "blade" with low rotation.