Hand tap (for stainless steel) (EX-SUS-HT) EX-SUS-HT OH2 #2 M6x1
- EX-SUS-HT OH2 #2 M6x1
- Package Qty.
- Ship pack of
- Work Material
- Stainless steel, copper
- Screw Diameter
- Pitch (mm)
- Angle Width K (mm)
- Lower Neck Part L1 (mm)
- Surface Processing
- Homogenized processing
- Overall Length L (mm)
- High-Vanadium Heiss (High speed steel) HSSE
- Number of Flutes
- Chamfer Lcf
- Angle Length Lk (mm)
- Screw Length Lc (mm)
- Shank Diameter d (phi mm)
- M6 and below have protruding centers.
Customers Who Viewed This Item Also Viewed
| 5 star
| 4 star
| 3 star
| 2 star
| 1 star
4 Customer Reviews
The reviews are automatic translation.
Cut the screws by hand in thin stainless
On 2016-01-07 07:47:15
When you're ready to turn off the small screws, old-fashioned in this form is the best. Going well do it in haste.
I because it is the worst and Ruru broken.
Make a screw to a stainless steel plate by hand
On 2015-12-29 16:46:37
Thin tapping is limited to manual labor. This is the most old-fashioned of the manual. After lubricant is required, but have come up a lot of good right now.
Cut a female screw in stainless steel by hand.
On 2015-12-28 18:41:58
This is the most is to turn off the thin female screw in stainless steel.
Its one internal thread is dead and repeated back and forth.
At the same, it is cutting oil also important factors.
Use the back eye camera when attached to the trailer chassis
On 2011-09-14 17:18:29
Stainless steel is still not using the tap very good iron
Customers Who Bought This Item Also Bought