Hand tap (for stainless steel) (EX-SUS-HT) EX-SUS-HT OH3 #2 M16x2
EX-SUS-HT OH3 #2 M16x2
Ship pack of
Stainless steel, copper
Overall Length L (mm)
Screw Length Lc (mm)
Shank Diameter d (phi mm)
High vanadium HSS (high speed steel) HSSE
Number of Flutes
Angle Width K (mm)
Lower Neck Part L1 (mm)
Customers Who Viewed This Item Also Viewed
5 Customer Reviews
The reviews are automatic translation.
Tap cutting of stainless steel plate
On 2017-05-30 18:49:28
I pierced the hole and worked carefully. I could tap cut without problems. Oil is essential. I got the counts in this series.
Cut the screw manually into thin stainless steel
On 2016-01-07 07:47:15
When cutting small screws, this old form is the best. I will go well if I keep up with it. It is the worst when you break.
Manually screw the stainless steel plate
On 2015-12-29 16:46:37
Thin tapping is limited to manual work. For traditional handwork this is the best. Lubricating oil is also essential, but a lot of good ones are out now.
Cut the female thread to stainless steel by hand.
On 2015-12-28 18:41:58
This is the best to cut a thin female thread on the stain. When repeating back and forth, the female thread is out of it. Also, cutting oil is an important factor.
Used when installing back eye camera in trailer chassis
On 2011-09-14 17:18:29
Stainless steel has not used taps yet but it is very good with iron
Customers Who Bought This Item Also Bought