The reviews are automatic translation.
Production of automotive electronic device
On 2017-12-07 23:57:17
In the case of a connector of a famous manufacturer, the manufacturer's genuine crimpers will also cost between 6 and 70,000 yen. However, this crimping machine can substitute adequately. And this price. No complaints.
On 2017-08-23 17:56:41
I sing precisely, but I occasionally slide and fail. Although the crimping surfaces are parallel, it would be better to reduce the effect of jumping out to the barrel shape. Because it is expensive and expensive, I wonder if I can spare that much effort ...
On 2016-11-27 22:23:33
Purchased for caulking JST's XH series connector. Considering the price of genuine tools, I think that it is sufficient performance. I practiced caulking a bit for a moment, but it went well.
During machine maintenance
On 2016-05-27 09:13:31
Accuracy is bad. Tooth angle is bad. The grip is too fat. I do not need rubber
On 2015-06-24 00:02:01
Previously, I used a maker's genuine tool at work. This tool is not dedicated, but as an amateur it is judged that processing is done to a sufficient quality level in order to use it for electronic work and a prototype for only one machine. I think that the price is affordable with one digit down of the manufacturer's genuine tool.
When wiring out from the base connector
On 2014-10-02 14:48:53
It was small and easy to securely crimped at a price of 1/10 of the manufacturer's genuine.
Crimping operation of thin connector
On 2013-07-24 15:50:27
Until now, I was crimping a thin connector with a radiopen etc. It is often that the wire will come out due to insufficient crimping. I am frustrated taking time. Working with this pliers makes it possible to shorten the time without making any mistakes and make crimping work fun. Although it is expensive a little, it has enough value.
Purchased to hit Molex's 50079 and 50125
On 2013-05-02 10:32:12
I purchased it because it was not shaped at all with my hand-held tool. Molex's 50079 and 50125 are quite difficult and can not be cleaned as if the housing shop hit it, but somehow a good result was obtained, it seems that you can be satisfied if you train a little more. The other terminals worked according to the "crimping result list" on the ENGINEER website and it was possible to crimp it wonderfully and neatly with no problem at all. However, in my case hand lighting and magnifying glass were essential. Mr. ENGINEER is glad to make detachable, lighted loupe ....
Crimp connection terminal
On 2012-08-05 14:22:17
Crimp of a small terminal such as the servo terminal of the radio control and the terminal of the electric fan used for the personal computer can be cleaned and accurate. I can even remember the finish. Although the amount is slightly higher, the dice can be done very well. I tried variously using shrimp or Hosan, but I think that this was a correct answer purchased.
It is used for contact crimping (making harness) of connector.
On 2010-03-01 00:53:11
I was glad that contact crimping was possible even if I did not hold it too strongly. Because I do not have much grip strength, I was anxious before purchasing. For now it works well with JST's XA (1.6 and 1.9), XH (1.6 and 1.9), EH (1.4 and 1.6), PA (1.4 and 1.6) and so on. There is also a die of 1.0 mm, but I do not have the opportunity to use it yet. I do not know about durability yet.