Due to the national holidays as Golden Week, we will close 2017/5/3~2017/5/5. This may cause delays with our responses. Thank you for your understanding.

Buy more than* S$200* and get FREE SHIPPING

  • Hand Lap, Glass, Pump Dispenser
  • Hand Lap, Glass, Pump Dispenser
  • Hand Lap, Glass, Pump Dispenser

Hand Lap, Glass, Pump Dispenser 200

2.67 (6)
Package Qty.
Ship pack of
15.76 SGD
In stock
Now we ship to...
...see all
Item Feature
Material (pump part)
Brass , nickel plating
Material (Tubes)
Fluoro-resin (PFA)
Overall Height (mm)
Material (Body)
Soda glass
AS ONE Part Number
Material (cover)
PP (polypropylene)
Diameter (phi mm)
Capacity (mL)
Customer Reviews
5 star 1
4 star 2
3 star 0
2 star 0
1 star 3
Review Rating: 2.67
6 Customer Reviews
The reviews are automatic translation.
Degreasing work (gasoline use)
From Japan
On 2017-03-10 21:52:30
I it is sufficient to stop at the first "click" outside cap is turned to the two-stage, but will be helluva not take and would fit all the way. To remove It must be withdrawn brute force and prepared to spill the contents. Less "usable amount of liquid" in due tube length is short, and the restless It must be added together poured. Since usability is bad another product to enter the order of 300CC I use to buy.
This review is about item#9155124.
For the cleaning of the electronic substrate
From Japan
On 2016-11-03 18:56:19
We are using put the anhydrous ethanol, but Ki can be used without problems It is very convenient. Cap will enter and a pop but it also felt like a little stiff.
This review is about item#9155124.
Taking out a solvent for wiping operation
From Japan
On 2013-12-26 16:16:38
Generally satisfied. Initially, caught is too large of a bottle body when you try to remove the outer cap from the bottle, is disengage was very difficult. It became so just the right condition the ledge of the outer cap inside and scraped off with a cutter knife, I would like to improve this point. The tube in has not reached to the bottom of the bottle, whether they do so there is a sense there is intent on the design. It is to be improved if the mere design mistake.
This review is about item#09155124.
Cleaning before printing.
From Japan
On 2011-08-23 22:00:29
Does not become useless in the resin portion is cracked and put the benzine after a few days. Because the non-returnable can not be it.
When alcohol wipe of
From Japan
On 2010-11-19 11:07:43
Because both hands can be used is useful. I was a little anxious to see the reviews, but it can be used without problems.
Using a solvent such as a flux remover of the printed circuit board
From Japan
On 2010-08-29 02:37:11
Tube (not reached the bottom) short, it can not be suction and small amount of liquid. Cap is I want you to screw. If the inner cap is loose, resulting in a liquid to scattering when removing the cap. It is likely to loose the inner cap. After one purchase, were two additional purchase, the two after, one inner cap loose immediately, one when the screw of the inner cap is not available become a fool, the latter two eventually Not available.
This review is about item#09155124.