The reviews are automatic translation.
Solder the printed circuit board (including self-made) and electronic parts etc. by electronic work
On 2015-11-28 03:27:19
To the soldering iron of the goot, I was worried about whether the problem would come out in various places such as heat conduction as well as size before purchase, but there was not any problem at all. I can use three without any problems with the first one. Depending on goot's soldering iron, even if you bake the sky around 30W, the durability is also high, and when using the repair agent for tip soldering, the part of the tip will return to near the new one. Therefore, it is still usable for more than 1 year for the first one. How much do you have to use the three you bought? Is it?
Prototype of small hydraulic power controller, fabrication of experimental equipment etc.
On 2014-05-21 15:29:58
I was able to exchange it correctly promptly.
Soldering of printed circuit board
On 2014-01-23 11:24:00
I am using it for soldering iron of other company's products, but it does not change as a genuine product without problems. Because it is MonotaRO product, it is appealing even in that it can purchase up to 15% OFF. If the tip is getting sore this time, it probably will be bought together. A better point than genuine is that the thickness of the soldering iron is about 0.5 to 1.0 mm thinner, it is a point that thermal adhesion with heat cover pipe can be prevented by thermal expansion. I've always exchanged small buds and heat cover pipes together, but with this it is not necessary to replace the heat cover pipes one by one. The cause of heat-wearing is that the genuine tip is ceramic-coated and the thickness is increased, the gap between the heat cover pipe is 0.3 mm or less, and the thermal expansion of the genuine tip is thicker .
Electronic board soldering work
On 2011-12-24 20:42:06
Again the new item is melting solder, adhesion is good at all, if you exchange early, quick work will last. I will continue to purchase.