The reviews are automatic translation.
On 2017-04-26 19:43:51
I bought it cheaply but it is easy to use a soldering iron without problems.
On 2017-03-31 12:59:22
It is not normally use the problem. It would not hurt to buy.
Maintenance work at the time
On 2017-03-02 16:51:59
You can use without problem in particular to cheap split. COSPA is the best of the recommended products.
On 2017-02-25 19:45:59
Hard to write it inserted located above outlet than I thought is. I think the angle is mounting screws may be mounted parallel to the top surface so that it can be easily adjusted.
On 2017-02-16 00:22:19
Since making is better than I thought COSPA is probably high
Production, such as a vacuum tube amplifier
On 2017-01-20 23:32:07
I was put at ease the hot soldering iron at an affordable size. You do not have to worry about, such as burns.
On 2016-12-14 11:37:53
Given well, and comes with a simple type soldering iron set, we use it. Here is a stability preeminent since become large.
A little more, cheap and glad you but ...
Required when solder used
On 2016-10-06 16:11:33
COSPA is high have also attached a sponge so had been shipped with the soldering iron is was something that cheap.
Production of printed circuit board
On 2016-09-15 08:40:07
There is discontent in every time you use. Subject to feel as commercialized not know the intended use of at product development. Stability is poor. Moving each time to clean the tip. Tips to ease, these are expected to stop using to buy the good as soon as possible there is a safe very concern.
Solder work of the printed circuit board
On 2016-09-11 14:32:04
Turin Handa sponge functions hesitation.
In general, the volume with the addition of water to function as increased and solder taking.
But the problem try using came out, because the water leak is easy and shallow grooves add water need to be careful.
Sponge in removing the solder it is necessary to take the solder at this time at the center. When it comes to the end, or a soldering iron destination and has been cleaning while Suberashi in the sponge go scattered around protruding solder ball from the sponge.
I think that is not suitable for people to increase the solder work.
In general, although there is no problem because there is a guard to the top of the sponge bulging, you must be careful because too shallow.