The reviews are automatic translation.
On 2017-03-24 18:14:57
There is no problem. In addition, it purchases if necessary.
Processing of aluminum panels
On 2016-02-29 21:28:56
Most have been used in dry machining of aluminum panel. In our, it is the most frequently used high end mill. Life I believe that reasonable. When it comes to life, sound change, cutting waste is slightly larger, also because a little rough cutting surface, prior to exiting symptoms, while checking the cutting edge in the magnifying glass, I try an early exchange.
Troubled very and no, we expect the replacement.
On 2016-01-12 16:17:34
I was used to the cutting of brass, but I have broken in the middle.
Sissy! I have the impression that.
Purchased for drilling of glass epoxy substrate
On 2015-08-12 09:55:51
Purchase to the elongated holes processed into glass-epoxy substrate. You can clean processing is a long hole in the drilling machine and Purokuson XY table. It became a favorite tool.
Out chemical wood plane
On 2015-02-27 11:01:17
Sharpness is better it may also have well.
On 2015-01-04 01:17:32
Was enough quality.
SUS304 8mm * 4L grooving
On 2014-11-28 16:46:39
Even for SUS304, you can use without problems
Durability, but I do not know yet
Cost is pretty cheap I think.
Plane processing of duralumin
On 2014-08-04 23:29:23
Cutting property is very well, I was able to comfortable cutting.
On 2014-03-21 13:12:17
While life is worrisome, it is somehow long-lasting.
Cut does not mean perfectly clean, but it is not comparable and polish a little.
We are using a router processing of wood.
On 2014-03-06 17:00:44
The wood there is a spiral bit of 6φ, but because of too expensive, we tried to substitute in this 6φ end mill.
Wood has been very happy to be processed as tofu.