The reviews are automatic translation.
By modeling machine
On 2015-07-24 23:39:15
Since cutting the tree have been used in the dry, but high for is not available because very much like the cutting edge in the heat would have been done, we are very handy.
Cutting of aluminum
On 2013-04-26 15:36:25
Cutting of aluminum was also completely OK. Finish also mochi is also good, very satisfied at this price!
Printed circuit board production
On 2013-03-31 16:03:22
Because the length of the blade is more than the thickness of the substrate, pretty good. In the past, I bought a short thing, there is that there was stiffness.
Since the long part of the blade, as well as pattern cut of the board only, also in drilling of large and small, also, can also be used for cutting of the substrate.
In the fabrication of printed circuit board, without the blade of the exchange, since a series of work is complete, very good.
Thin blade want if possible, but painful not buy expensive.
On 2012-12-25 11:31:11
Price was cheap because the 1000 processing, but could be used lavishly
3D cut of relief
On 2012-09-27 19:41:05
Was never particularly a problem, such as sharpness. Since the price is cheap and easy to use.
On 2012-09-04 16:27:47
When new the sharpness is good. Some life, but is short, no problem and from the price.
Concave cutting of brass material.
On 2012-03-18 20:14:42
Opponent was shaved Kokimiyoku because it is brass material. Dimensional accuracy was also good enough in performance because it is a relatively minor processing.
Delivery time was possible to correspond quickly and hurry.
Of price to was satisfactory.
To NC machine tools
On 2012-03-15 11:17:06
This is a great sharpness to inexpensive
On 2011-10-29 11:51:31
There was no problem because A7075P is subject material this time.
Currently, the subject material is Heavy Alloy such as tungsten cult, carbide drill, end mill, tap, reamer, and the selection of the etc., available to you in trouble in the cutting conditions.
The processing of common material (Monotarou) does not have all the problems, but its such a processing cost is cheap, also, at present, it is the competition for work in the price cut. In the other is the middle of the thing difficult of processing we're working, but you cage in trouble on the tool costs are high selection. So, if there is something that (advice) with experts concerning the processing is able, I think to survive also customer side, it can also contribute to the sale?
Such as aluminum and SUS and resin
On 2011-10-12 16:30:31
Since the shank diameter had no choice when it comes to 3mm, was this. A feeling of use would be nice products in terms of the cost performance.