The reviews are automatic translation.
When attaching the drill chuck to the lathe spindle
On 2017-07-20 18:10:18
If you work with the end mill on the lathe chuck, the eccentricity will affect and it will not be able to be cleaned smoothly so expect to install the drill chuck mounted on the core pushing table side without swinging, so that the Morse taper of the spindle and the tailstock Buy this sleeve to absorb the difference. Although the drill chuck could be installed as desired, the accuracy of the drill chuck was not as high as expected, and the eccentricity of the drill and end mill was almost the same as that of the three claw chuck. Well let's say that it can be used for things that are difficult to grip with three claws such as a small diameter drill. Since the eccentricity of the sleeve itself can not be detected with the dial gauge, it has sufficient accuracy.
On 2017-05-16 09:10:13
It is cheap and can be purchased and used without problems. It is comparable to a famous manufacturer. It is a good product.
I use it with radial drilling machine.
On 2017-01-27 08:14:17
It is enough to use for dust and it can be used without the drawbacks like this.
For attaching a tapered drill, use MT3 → MT2 sleeve.
On 2016-06-08 09:39:02
No problem at all.
On 2016-02-01 20:52:54
Especially it can be used without problems. I would like a lineup of 1 * 4 as well.
Drilling · Radial drilling machine
On 2015-05-25 15:14:25
A lot of monstaro brands are cheap and bad, but this is an unusual and one that can be used without problems.
I use it as a part for mini lathe tail stock.
On 2015-04-10 14:01:42
It is not special, but it is usable normally.
Drill chuck for conversion
On 2014-01-10 17:21:51
If you can not swing it down to a narrow place on the MT3 drill chuck on a desk milling machine, attaching a drill chuck of the MT2 of the desk lathe with the mediation of this sleeve makes it possible to cut the narrow area at its limit. To the extent that accuracy can also be allowed, it is very helpful.
Making arbor for mini milling
On 2013-07-20 11:29:05
I am using a mini lathe (CL - 300) and a mini - milling cutter (X - 1) for prototyping. I bought MT - 2 -> MT - 1 and MT 3 -> MT 2. The main spindle of the mini lathe was MT - 3, the tailstock was MT - 2, the collet of X 1 was MT - 2, and the adapter was cut with CL - 300, but even a sharp razor sharply waves and the core does not come out (1/100 I will go out) so I bought it. Is good. It might be possible to purchase without having forgotten that drift or arbor comes out with an affiliate. Also, in prototypes you may want something that you can not burn, so it will be helpful if there is material and quenching.
Use of tapered shank drill in MC or drilling machine.
On 2013-07-11 22:10:03
Although it may be by chance, it seems that the core system has not been out of 0.06 place, so if it is a hole drilling, drilling machine processing, it is not a problem. Hole machining with MC is not problematic if it is machined at low speed, but it seems that machining in the high speed range will have an effect. In addition, it seems that problems will arise from the drill chuck's use as a sleeve from the JT taper to the MT taper with accuracy. If you only want to process with MT shank tool with something that does not need accuracy, I think that it is suitable for using it by attaching it to a drill etc that you purchase in large quantities and arrange a number and use it well .