The reviews are automatic translation.
On 2017-05-16 09:10:13
It is cheap and can be purchased and used without problems. It is comparable to a famous manufacturer. It is a good product.
I'm using a radial drilling machine.
On 2017-01-27 08:14:17
Sufficient to use to Kiri, this like we can also be used without drawbacks.
Use the sleeve of MT3 → MT2 for taper drill mounting.
On 2016-06-08 09:39:02
At all no problem.
On 2016-02-01 20:52:54
In particular, you can use without any problems. 1 * 4 is also want you to line up.
Drilling · Radial drilling machine
On 2015-05-25 15:14:25
A lot of monstaro brands are cheap and bad, but this is an unusual and one that can be used without problems.
I use it as a part for mini lathe tail stock.
On 2015-04-10 14:01:42
It is not special, but it is usable normally.
Drill chuck for conversion
On 2014-01-10 17:21:51
If you can not swing it down to a narrow place on the MT3 drill chuck on a desk milling machine, attaching a drill chuck of the MT2 of the desk lathe with the mediation of this sleeve makes it possible to cut the narrow area at its limit. To the extent that accuracy can also be allowed, it is very helpful.
Making arbor for mini milling
On 2013-07-20 11:29:05
I am using a mini lathe (CL - 300) and a mini - milling cutter (X - 1) for prototyping. I bought MT - 2 -> MT - 1 and MT 3 -> MT 2. The main spindle of the mini lathe was MT - 3, the tailstock was MT - 2, the collet of X 1 was MT - 2, and the adapter was cut with CL - 300, but even a sharp razor sharply waves and the core does not come out (1/100 I will go out) so I bought it. Is good. It might be possible to purchase without having forgotten that drift or arbor comes out with an affiliate. Also, in prototypes you may want something that you can not burn, so it will be helpful if there is material and quenching.
Use of tapered shank drill in MC or drilling machine.
On 2013-07-11 22:10:03
Although it may be by chance, it seems that the core system has not been out of 0.06 place, so if it is a hole drilling, drilling machine processing, it is not a problem. Hole machining with MC is not problematic if it is machined at low speed, but it seems that machining in the high speed range will have an effect. In addition, it seems that problems will arise from the drill chuck's use as a sleeve from the JT taper to the MT taper with accuracy. If you only want to process with MT shank tool with something that does not need accuracy, I think that it is suitable for using it by attaching it to a drill etc that you purchase in large quantities and arrange a number and use it well .
On 2013-01-12 08:02:05
Accuracy is good, cost performance is the best.