Buy more than* S$200* and get FREE SHIPPING

Customer Reviews of Carbide Cut-Off Inserts

Carbide Cut-Off Inserts
Sales Price: 67.22 SGD
Review Rating: 4.00
10 Customer Reviews
5 star 5
4 star 3
3 star 0
2 star 1
1 star 1
The reviews are automatic translation.
Showing 1 - 10 of 10 Reviews
Processed product production
5
From Japan
On 2017-04-14 15:39:03
It is used for original production such as cutting and cutting.
This review is about item#37631535.
lathe
1
From Japan
On 2017-04-07 11:50:39
Since the distance from the edge of the breaker to the breaker groove is too far, the facet does not round and straight out and it is dangerous and can not be used.
Cutting of sleeve
5
From Japan
On 2016-06-28 18:23:07
I cut the thick sleeve of S45C, but it was able to perform stable processing.
This review is about item#37631535.
Metal Processing
2
From Japan
On 2016-03-08 21:48:14
Decrease faster
This review is about item#37631535.
lathe
5
From Japan
On 2014-05-22 22:01:23
For now it is using it without problems. Sharpness is also good and I have not used much yet, but I think that it seems to have durability.
This review is about item#37631535.
lathe
5
From Japan
On 2012-07-19 00:33:14
Cost · Usability is OK. Currently it is installed and used in a holder made in China.
This review is about item#37631535.
I use it by cutting it. This time for the first time I used the MonotaRO chip.
4
From Japan
On 2012-03-14 21:44:44
Although it is an impression that I used cutting chip, I use only aluminum 17S and iron 1215, but there is no problem, I have never replaced chips. We do not use stain 304 etc, so we do not understand yet. Since it is attached to the holder of Iskkar, the price is cheap and it is saved. Improvement point etc. I do not understand yet, but I think that I would like to impress again when using it such as Sten 304 in the future.
This review is about item#37631535.
Pipe cutting
4
From Japan
On 2012-03-12 23:08:41
I could not cut it and cut it.
This review is about item#37631535.
Cutting off the NC lathe.
5
From Japan
On 2012-03-02 15:38:13
It can also be used for SUS304 * SUS316, it is a very reasonable break-through chip.
This review is about item#37631535.
Cutting of iron, stainless steel, hard aluminum.
4
From Japan
On 2012-01-20 12:32:39
The workpiece is P type (steel), but with light cutting, there is no particular problem with either stainless steel or aluminum. Compared to Ishikaru genuine, it is not visible and it is not bad, but I will consider whether to continue also next time. (I think that it will take several years depending on how often I use it.) If possible, I would like blades to be added to the lineup.
This review is about item#37631535.
1
Customer Who Viewed This Item Also Viewed
Cutting tip
Carbide Cut-Off Inserts Holder
Holder
Chip GDM
Insert
Insert