Customer Reviews of Keyless Chuck
The reviews are automatic translation.
Showing 1 - 5 of 5 Reviews
Used in NC milling machine
On 2017-03-17 19:11:18
Cost performance lost extra large spanner attachment
Drilling with a drilling machine
On 2016-09-06 16:31:25
The bearings became gorillory for about two weeks after I started using them. (Although it is not even bumping ...) The long front model of the knurling part is disappointing although it was durable comparable to the manufacturer's product.
Normally used for machining
On 2016-06-01 08:34:32
Since Albrecht got broken, I tried it for trial. I am satisfied enough that I can buy it below half of Albrecht.
On 2015-11-27 05:50:28
I use it attached to the Hitachi drilling board We firmly chew, so the end mill will not be shifted I think that I should have purchased it sooner
Used in small milling machine
On 2015-04-24 20:54:03
I purchased it with Arbor and assembled it, I felt good, I still do not use it for the product, but I think that it can be used a little though.
Customers Who Viewed This Item Also Bought
75.19 - 109.90 SGD
10.52 - 29.51 SGD