Buy more than* S$200* and get FREE SHIPPING

Customer Reviews of High Speed Steel End Mill For Aluminum (2 Flute)

High Speed Steel End Mill For Aluminum (2 Flute)
Sales Price: 13.79 SGD
Review Rating: 4.18
11 Customer Reviews
5 star 7
4 star 2
3 star 0
2 star 1
1 star 1
The reviews are automatic translation.
Showing 1 - 11 of 11 Reviews
Hobby CNC
5
From Japan
On 2017-10-08 13:18:41
I am using it for processing aluminum. Chipping is harder than cemented carbide.
This review is about item#19044524.
Use cnc
5
From Japan
On 2017-08-08 14:31:07
Sharpness is very good feeling. It is saved because the price is also cheap.
This review is about item#19044524.
Parts processing.
5
From Japan
On 2017-07-06 15:34:21
I think that sharpness was good compared with other manufacturer's products and made a good choice. I would appreciate it if the blade width is 18 mm with the same shank.
This review is about item#19044603.
Cutting
5
From Japan
On 2017-04-11 15:38:41
Being cheap, very sharp and well finished are clean. It can be used without problems.
This review is about item#19044585.
AL cutting
4
From Japan
On 2017-04-08 15:01:59
It seems that it is peeled for light cutting, but its durability can be polished so that it is being used with pin angle attention
This review is about item#19044497.
Cutting of A5052 with CNC
2
From Japan
On 2017-03-09 08:37:09
Several pieces were used but the sharpness was not good. It fuzzs and is rough. Compared with other companies there is no sharpness on the side blade. Hitachi is absolutely better although there is a little price difference.
This review is about item#19044497.
Aluminum processing by NC machine tool
1
From Japan
On 2016-09-26 10:16:57
Although sharpness is good, holding of a blade is very bad, sharpness falls and it breaks at its worst. It is best to replace when sharpness comes down, but the replacement cycle is very short, so I feel like the end mill does not differ from the ordinary end mill in terms of cost ...
This review is about item#19044576.
Plastic cutting processing
4
From Japan
On 2016-08-02 18:55:52
Because it was used in plastic cutting, it can be cracked crisp. Wear of the bottom blade was slightly early, the facial aspect was not so good
This review is about item#19044567.
During processing
5
From Japan
On 2016-05-26 16:28:12
Although other companies are too expensive, they are tolerable. The difficulty of sharpness sharpness is that it is possible to cope well and cut down costs as long as polishing tip
This review is about item#19044506.
Cutting of aluminum alloy
5
From Japan
On 2016-05-11 18:06:24
Even compared with the maker's products it is scaled as well. I still do not know the durability performance.
This review is about item#19044567.
Used in machining
5
From Japan
On 2016-03-24 16:51:44
Sharpness is comparable to other companies, but it would be nice to have a bit more blade
This review is about item#19044542.
1
Customer Who Viewed This Item Also Viewed
End mill for aluminum
NK end-mills  for Two cutting-edge long cutting edge
2 flute ball end mill HSS
Steel Butt Hinges
2 flute Medium HSS end mill