Blades

Round blade for double bar. For deburring sheet metal. The entire circumference on both sides can be used as a cutting edge.

75 x 3.2 mm high-speed steel triangular scraper

Double-headed, triangular scraper with a blade width of 7 mm and a total length of 120 mm. Hold directly with the unihandle.

There are cutting edges on both ends, and it can cut both clockwise and counterclockwise. For cross holes

Double-headed middle-sized scraper. Hold with a midi scraper.

There are cutting edges on both ends, and it can cut both clockwise and counterclockwise. For cross holes For RC2200

3.2mm shaft, total length 49mm, 45 ° inner diameter scraper for cross hole. Hold it in the D holder.

For heavy cutting of steel, aluminum, etc. Single-edged, right-handed only. Spare blade for three * The blade is sharp and dangerous. Please handle with care.

A blade that creates an escape in the corner. Since it is symmetrical, it can be used in both directions.

Round blade for double deburring bar. The entire circumference is a cutting edge. Parts for double deburring bar *Do not use for anything other than its intended purpose. *The blade may be damaged and scattered. *Please wear work glasses and gloves during work.