The reviews are automatic translation.
Supplement wiring mistakes on printed circuit board
On 2018-02-01 00:09:42
Mis-wiring of printed circuit board was discovered after solder mounting. Since it is high density mounting, there is no space. There was SSOP on IC. It was able to escape the difficulty by solder reflowing 1005 SMD chip resistor and capacitor in the additional circuit made by cutting knife this product here. If you want a greedy foil thickness 75 & micro; m was about half that of 35 & micro; m it was easy to do.
Magnetic shield measures
On 2018-01-13 23:38:51
I used it for the magnetic shield of the antenna. I think that it was easy to work if it was a bit thinner.
For stained glass
On 2017-07-06 17:51:50
I bought it because it was displayed by searching "stained glass"
Peel off when washing detergent. It can not be used for stained glass.
Used as a jig
On 2016-09-29 16:32:26
Conductivity can also be used without problems.
Noise shield when installing automotive electrical equipment
On 2016-08-26 01:12:24
When installing video equipment, such as drive recorder, when noise enters navi, terrestrial digital TV, etc., it is trying to reduce noise by shielding to antenna cable etc.
Conducted heat retention
On 2016-04-13 11:15:25
Ideal for keeping heat.
Measures against noise of motor
On 2016-03-24 15:45:51
Adhesion is good and usability is good.
To the material of model production
On 2015-09-03 07:36:39
I used it as a material for a sail boat model. As far as I looked it was the cheapest so I made it a line. It was easy to use because the thickness is Sokosoko firm.
We use it to suppress electromagnetic pulses.
On 2014-01-24 00:43:35
It is easy to use. Whether or not the adhesive surface will weaken after a while.
Shielding of electromagnetic waves
On 2013-08-21 08:53:56
It is excellent in cost performance, and it is appreciated that it can be used as expected. However, compared with other companies' products, somewhat, the material is hard (may be due to the thickness) processability is slightly inferior. Also, we do not know the condition of the surface treatment, but oxidation of the surface is fast, especially when moisture etc. is attached, if it leaves it will be discolored, so be careful. Recommended for those who place importance on cost.