The reviews are automatic translation.
In a piping with heat
On 2018-11-09 14:35:20
It used for piping through which high temperature gas passes.
Normally iron made is rusty and it is hard to break. Even if it is painted to prevent rust, it gets burned and it rusts immediately.
Even with initial cost it is better to make it stainless steel.
Even if it is cheap, the monotaro brands are patronizing because there is no quality problem.
On 2018-11-06 18:03:33
I purchased it because it is cheapest among stainless steel products.
There was no problem in use such as processing precision.
High pressure line of air compressor
On 2018-11-04 17:25:30
Although it is good with brass or copper at low pressure, I purchased it because it is insecure because it is high pressure air. Especially without burrs and fuzzing, making is polite. I think that it is good.
On 2018-09-05 17:23:28
It is saved because the SUS elbow can be obtained at this price.
The accuracy of the screw was also no problem.
For scattering spray
On 2018-06-23 20:43:54
I bought it because the price is cheap but it was thick and I felt a bit heavy.
Air hose fitting
On 2018-06-20 21:53:15
There was no chamfering or dust adhesion and the finished condition was good, and I felt that there was no garbage even if used as it was.
On 2018-05-31 17:23:14
I could use it normally. It is better if it is strong against freezing.
On 2018-04-23 14:57:14
It's fine, especially because it is stainless so it is strong for rust, so I like it.
Hot water supply pipe
On 2018-04-16 12:56:29
I bought several and had two pinsols.
I gave up that hit was bad.
On 2018-03-15 19:08:53
After all it was uneasy because it is not a manufacturer item
I could use it normally