Incorrectly welding the socket of the taper processing to the place where the parallel screw equipment is attached, the screw of the equipment does not match. I attempted to correct at this tap, but in the first place, the blade was missing. Tap was also very shocking because it is not cheap as much as the size is large. It was regrettable because we managed to do something because it was two places in all.
Because it is impossible to screw a G type level sensor into a normal gas screw (parallel screw) socket, it is a translation that tapped the screw with the G type tap purchased this time.
On 2013-07-16 17:37:15
It is a translation of a gas screw parallel socket to a G type gas screw tap, but it was quite difficult situation to screw in the first one mountain. I thought it would be easier if the tip was a little thinner. Postscript: In normal G type (taper type), since almost no G type parts which we are seeking are included, we purchased a straight type. I do not have any products, so I am concerned whether actual claims will come.