The reviews are automatic translation.
Used for repair soldering work of wiring relation. There is no problem even at low price.
On 2018-06-13 15:46:48
Because it is inexpensive and there is no problem at all for use, there is no improvement point separately.
To wash the ironing iron
On 2017-08-16 15:43:20
When used for a long time, the sponge will also deteriorate ...
It is reasonable and you can use it enough, it is recommended.
When soldering ICs which are weak to heat, keep moisture in them,
It is also recommended to use it for cooling.
Used for sponge replacement
On 2017-04-30 01:29:27
There was also in other people's impression, but since the thickness is thin, I would like you to increase the thickness by decreasing the number of sheets.
On 2017-04-05 15:32:52
Even if it gets dirty it can be replaced without fuss. I will buy it again when it runs out
On 2016-06-13 18:18:53
Semi-attached table Used cut out according to the size of the attached sponge. Use squeezed water each time it is used. Convenient for the maintenance of the tip.
I am using it on the table of HAKKO 936
On 2014-03-21 16:23:15
HAKKO 936 Although the width is slightly smaller than the sponge of the soldering iron, it can be used satisfactorily. I use holes using a compass cutter in advance in about 10 mm holes. Because the price is cheap, I exchange it without hesitation.
On 2013-05-13 00:47:24
It's so handy because it's thin, but it's cheap so it's good. Since the roughness of the eyes is conspicuous, it is not used on the surface. You should strengthen the solder cleaning at the four corners.
Replacement sponge of soldering iron base
On 2013-01-18 13:46:04
It is reasonable
Soldering iron tip cleaning
On 2013-01-12 13:35:46
It is hard to use because its eyes are coarse a bit.
For soldering iron replacement
On 2012-06-12 20:39:51
It is thinner than usual impression and impressive to use. I do not mind having to reduce the number of sheets so I think that it will be easier to use if you let two sheets be one thick.