The reviews are automatic translation.
Point hole processing at NC
On 2018-01-25 15:23:19
Previously, I used a drill with a tip anti-shake cut before opening the positioning hole, but I also decided to use this spotting drill because the depth is also unnecessary.
Groove processing is less sturdy, I am satisfied that it can be positioned neatly without blurring.
Chamfer during drilling
On 2017-11-22 15:18:44
Although it was used for chamfering of drilling of Suj 2, it was able to be used without any problem although 3000 pieces were processed.
As a leading drill in a milling machine and machining center
On 2017-11-01 16:19:02
Purchased in September 2017. Because it changed from the former cutting edge shape, regrinding with a polishing machine became difficult. There were variations in the shank diameter and some collets for end mills were thick and could not be grasped. What I bought in 2016 was good, but I do not think it's good after change.
Used for 90 degree chamfering
On 2017-05-24 17:29:20
The biting during processing is good, the surface roughness is also clean, the cost is also inexpensive and very good compared with the major manufacturer.
Chamfering of drilling
On 2017-04-21 14:31:37
It is disappointing that the price is reasonable, durability is not different from domestic products and it is not felt that handling is terminated depending on the size
On 2017-03-24 16:26:05
Basically there is no problem, but in terms of durability, it drops compared with those of Nazi Nogi. Because the price is also cheap, it can not be helped. . .
Used for dish of small diameter countersunk screws
On 2017-03-03 22:45:29
I am satisfied because I could buy with affordable price without problem in the use feeling.
For dish hole drilling hole machining
On 2016-10-26 14:52:00
I used something of 5φ and 6φ so far so I bought a new 8φ. I love the tip angle 90 degrees and the good fit of the screws.
Machining character hole with milling machine
On 2016-05-31 18:29:17
It is good not to break even if the moving speed is increased.
Use for M8 dish screw
On 2015-09-11 15:41:05
I used it for taking dishes of stainless steel, but it was very good.