The reviews are automatic translation.
Cutting of aluminum, stainless steel, iron etc.
On 2018-10-24 20:44:16
I used it variously, but now I can not find anything better than this one.
It is most suitable for battery type disk grinder, because it is a thin blade hard to apply a load to the motor Stainless steel is also hard to burn.
Cutting of stainless steel
On 2018-10-17 15:42:32
At the home center, I tried purchasing it as "This is good" from the employee I purchased. Usability was good
Stainless steel cut
On 2017-06-26 17:51:41
It is outstanding sharpness I have used other items until now but I will buy it again
When cutting of iron
On 2017-06-14 19:59:17
I feel that the response when cutting is very soft and feel less sparky.
Cutting of iron industrial ironworking material
On 2017-04-05 22:16:08
Anyway, it will be short and it will not decrease easily. Wearing a disaster prevention surface, if you use it looking so that the blade is parallel to the cut, it will last for a considerable time. It is probably why it is also good to have a blade thickness of 0.8 mm. It is a product you want to repeat.
Cutting of member
On 2016-09-30 12:38:55
Because it is thin, it cuts easily but it will spill the blade immediately. Even if it subtracts it, it's convenient and repeats. Although I am slightly dissatisfied with the cost, once I use it I do not want to use 1.0 mm.
On 2016-08-25 22:44:38
Although the sharpness is satisfied, it is a drawback that the abrasion of the whetstone is very fast.
Cutting of steel material etc.
On 2016-07-08 11:10:42
It is good balance of sharpness and price, because it is thin, it has good cutting ability and it is good to cut it at thin thickness of about 1 mm, it is good because weakness is thin, but it is slightly faster but price is cheap but I do not mind, this is only a few years ago I do not use it, I like it very much.
Cutting of thin iron plate, aluminum plate, steel pipe, flat bar
On 2016-04-28 20:17:36
I think there is no further grindstone with the best sharpness. Calculate it to 0.5 mm and cut it.
Cutting of stainless steel plate and pipe etc.
On 2015-06-17 21:58:28
It was very good that I was recommended and recommended for workers. I can cut it just by applying it instead of pressing it, I feel very much less cutting edge.