The reviews are automatic translation.
Hydraulic jack maintenance
On 2018-12-28 19:29:37
Even in the summer when the temperature of the high pressure hose increased and a little oil pressure remained, I could operate with a light force.
Since I could not insert the original plug, I also bought HP-2P.
On 2018-09-07 22:16:38
I was able to check the operation very smoothly. Since I think that use frequency is low, there is no problem.
When machine attachments are exchanged
On 2018-07-26 18:43:45
Connection is smooth, very easy to use, 4P, 6P connection is also possible and very convenient coupler.
Replacement of hydraulic fitting of machine
On 2018-06-28 08:15:31
If it is our use, it is enough for this.
From the manufacturer of the machine, genuine products were said to be 10,000 in the male and female set.
On 2018-06-20 14:34:08
Quality is expensive but cheap, it is wonderful. There are a few oil leaks when the female is removed.
Hydraulic Farm Equipment
On 2018-03-19 12:23:22
I do not care about the standard coupler such as Nipro or Kovasi, how it differs, whether the mouth hits or the inside is narrow. Of course the size (nominal diameter) is correct, sockets attached to Kubota and Iseki tractors are no problem. Osaka souls would be hooked, but that does not help. Since there is no detailed description, shopping for a monotaro is wasteful.
Connection of attachment of construction machine
On 2017-12-15 07:43:44
It is cheap and very much appreciated. If it is possible to connect with the product of N company as well as the plug, I think that the range of use expands and it is very good.
Machine manufacture and maintenance
On 2017-06-19 20:32:15
It is incompatible with general things (international standards), so it can not be connected and returned.
Pressed by feeding gel coat.
On 2017-03-26 02:52:05
Even if it was used at high pressure, it did not leak even if separating the coupler, but I was using it very satisfactorily, but the O ring was broken and leaked and it became unusable. I asked for O ring separately, but there is no handling of I ring only. And the answer is ...
It is used for indoor high pressure hose connection during high pressure washing operation.
On 2013-01-15 13:20:29
It is used for the high pressure hose connection when indoors high pressure washing work (high pressure washing work for buildings and condominiums). Valves are built in both sockets and plugs, so when you disconnect the high pressure hose it is possible to work without contamination around the hose with almost no spillage. As a desired improvement point, there was a case where the coupler contacted some kind of obstacle and pulled out at the time of routing the hose during operation. There was no thing that water was drained by virtue of the built-in valves, but in the event that small garbage burns occurred in the internal organs valve section, in some cases the water blows out, so it is safe if possible with a lock function if possible is. When purchasing this product, I tried various investigations, but I could not find anything with a quarter size equivalent with other manufacturers with locking function.