The reviews are automatic translation.
When transmitting the rotation of the shaft of the motor and the wheel
On 2018-05-20 16:43:29
In the state I received it was a little troublesome that there was no way to fasten with the shaft and the point that I had to extend from the prepared hole was a little troublesome and I thought that this price was included, I was satisfied with the price and quality ing.
Pulley change of electric sewing machine
On 2017-10-18 23:00:41
Electric sewing machine thread breakage and needle bending continued more than before but suddenly the plastic pulley broke into two. When I was searching for a pulley of the same standard I was able to reach the perfect thing. Processing of the hole diameter and tapping of the set screw were necessary, but after replacement there was no timing deviation at all and a thick cloth became to be able to sew with no problem and it is satisfactory. Performance improved reliably.
Table saw movement guide remodeling
On 2016-04-23 07:52:47
Parallel to the cutting edge of the table saw, we made remodeling of the guide which is easy to move accurately at right angles. In order to move the guide in parallel, the two rotating shafts are synchronously connected. Purchased this pulley and timing belt. Dimensions of the pulley posted on the homepage were all written, so I got lost. Although a donut-shaped ring has a description to prevent coming off just by fitting, I do not understand well in sentences. I think that you do not need letters if there is an explanatory diagram.
Alternative for motor pulley
On 2016-03-17 09:42:20
Third-party products are integrally molded, but we chose it because the price is cheaper. I purchased it again because it can be used in the same way.
For transmission of spindle rotation of mini machine tool
On 2016-02-13 16:04:19
Although it is normal as a product, there is no problem, but if it is possible, it would be a good idea to have a pulley made of aluminum material, is not it possible to make it a bit cheaper in terms of price? .
Used for manufacturing transmission of rotation of mini chuck of spindle
On 2016-02-11 18:56:52
There is no problem as usual as a product, but it is saved if there is aluminum material if possible. If so, would not it be possible to make it a little cheaper in terms of price?