The reviews are automatic translation.
Waterproofing of LED bar light
On 2018-07-08 18:09:49
It will be helpful if the minimum unit is 1 meter
Three are wasted until you do not use a lot at once
Waterproof treatment of electric parts
On 2018-06-30 18:09:24
I used this size from before
Look for it out of stock and buy it here
Up to the last time I ran to buy Nagoya's Osu
Mail order is still easy.
Regarding products, the shrinkage rate is larger than the previous one
I think that the range of use has become wider.
After cutting the SUP paddle for length adjustment, it could be used to protect the adhesive part of the blade and the handle.
On 2018-05-26 07:32:16
It was also stretchy, thick and durable and could be used without problems.
Protection of self-made circuits
On 2018-05-23 22:41:07
It is an inner diameter sufficient to protect the universal board with electronic parts with the parts. However, it is a difficult point to have 5 pairs. There is enough length with one.
Prevention of fraying of trail entrance
On 2018-04-02 00:05:34
Since I have not used it yet, I can not say nothing. I bought it at home center until now.
I used it for grip reinforcement of the fishing rod.
On 2018-02-28 18:30:48
It is a material which has been thickened as well as finished.
A certain amount of heat is necessary for heat shrinkage, so it takes time in general dryer level
I worked with an alcohol lamp.
I think that it is most suitable for metal coating than resin relation.
Anti-slip for locking key when pulling fish, slip on bonito rod, surface protection of hose
On 2018-02-07 08:04:31
Extremely convenient because it does not slip when pulling out over 40 k of Kihadamagro
Protection of piped tight seal
On 2018-01-04 16:20:45
It protects it so as not to lose it by peeling it over the name seal of various parts.
Production of amateur radio antenna for car
On 2017-07-31 19:40:20
Excellent durability (rain, snow, ultraviolet rays, etc.) It is easy to produce wireless antennas.
Easy case of electronic parts
On 2017-04-29 20:31:18
Purchased for easy insulation of electronic components. Even if there is somewhat unevenness it will wrap tightly without tearing and it will look somewhat whitish but if it is about the emission of LED. Because there is flexibility, if you place the tact switch if you think about height, you can not press it.