The reviews are automatic translation.
On 2019-03-22 17:08:41
It is a necessary and sufficient item.
Actually I wanted shaft hole 50φ, but the only disappointing point is up to 45φ in this standard.
However, it is appreciated that the 45φ shaft hole is open and not only the push screw but also the key groove is carved.
It used to be for machining, and wages were higher than Sploque.
When replaced with a new standard motor, the shaft size has changed so it is used.
On 2018-11-04 10:27:17
It is quenched and can be relieved in terms of life span.
Also, since machining accuracy of the shaft hole is good, it gets scratched into the motor shaft.
During machine maintenance
On 2018-08-04 15:39:05
I used the shaft hole finished product for the deceleration motor, it is okay to eliminate the perfect size.
On 2016-01-29 10:07:06
I am very thankful for shaft hole processing products. We are satisfied with both quality and price of products.
On 2016-01-29 10:05:54
I am very thankful for shaft hole processing products. However, this time it was somewhat difficult to use because there was shake in the shaft hole. I think that the quality of the product is easy to use without problems.
Reduction ratio reduction
On 2015-12-24 00:13:55
The price is handy and handy.
Modification due to failure of drive unit
On 2014-06-14 00:20:31
Used for geared motor spindle
On 2013-11-18 09:22:23
I was a little worried because the price is a cheap PB item, but no problems at all. Dimensional precision is also good and workability does not change without problems in installation, so I think that I will continue to use it.
As a conductive part of a product
On 2012-02-24 08:28:58
Although I am using it several times, it is usable without any problems. Cost is down because price is also cheap and hole processing is attached. I will also use it.