Buy more than* S$200* and get FREE SHIPPING
Due to the maintenance, we will close our website from July 21,2018 10PM to July 22, 2018 4AM JST.
All customers cannot shop on our website during the time. Thank you.
It is a structure that is very likely to cause errors in accuracy, and during use the fixing screws of the gradient bubble gauge will loosen enough to say all and the gradient will be incorrectly marked. The part which should not move absolutely moves easily. It will not be a business tool.
Basically it is a use premise for external work, it is always used in an environment where mud dirt adheres, but because notation such as gradient notation and upstream, downstream notation etc (gray character of black character base material) It is difficult to check on. I think that it is a good product if you can improve the notation matter a little more easily.
First of all, I will do my fault. Since both ends of the cut end finish of aluminum were too sharp, I thought that as a finishing, I had to finish with a feeling of slightly dropping burrs and make it as smooth as the tool would be useless as a tool. The point that I bought was a short one so I thought that it was very easy to use because I bought one with two slopes of 1/100 and 1/50 with short construction. As an improvement point, when looking at the level of the actual mass, I used a horizontal instrument which is in the pocket behind the work pants or the waist bag, so I thought that it was hard to use unless it was made shorter. As a function to add, how about improving attaching a circle attached with a protractor on the back of the circle looking at the horizon etc of the mass so that various angles can be seen not only at the angle of 45 degrees but also at 45 degrees Is it? I am sorry for the selfish proposal, so I will use it as important because it is easy to use with the current leveling equipment. We sincerely ask you to develop wonderful tools ~