The reviews are automatic translation.
Maintenance of motorcycles
On 2018-08-01 16:04:30
It is handy to replace the piston inside the brake caliper.
Since the lock function is attached, I can not grasp it, so I get a lot of work.
From now on, I would like to recommend it to my friends.
Overhaul of brake caliper
On 2018-07-18 22:04:22
Although it was used to take out the piston during the caliper overhaul of the Land Cruiser front, the part of the screw fastening was brittle, the screw slid laterally and the part of the handle could not be fixed. When I managed to close it with pliers and use it, the teeth did not stand at all on the piston that was fixed. Finally, the screw fastening part broke. Although I made it over 2000 yen, I regretted buying it because it broke down at one time.
Brake caliper for motorcycle O / H
On 2018-07-06 17:43:40
I bought it to pull out the piston of Brembo's brake caliper. Even if you do not disassemble the caliper body it is satisfactory because the piston was removed.
Motorcycle brake maintenance
On 2018-06-20 15:26:58
I think that it can be used cheaply.
I do not use so much so I wonder if this is enough.
On 2018-06-12 10:44:43
I used it for disassembling the caliper of a new astringent of movement.
The lock function is on the verge of collapse with the fourth piston.
It seems that there is no problem if it is loose piston.
Knurled at the tip also slips and scratches if it is astringent piston.
I rubbed the rubber plate and made it slip.
Used in 4 opposed 4 pots and opposed 2 pots. It is almost just size.
I think that it can not be used for a car caliper.
Cleaning brake caliper
On 2018-06-02 19:01:25
I think that it is better to be able to fix with screws.
It was hard to turn the piston, too, I fixed it with the screw at the last minute, and gripped easily from there and got it easy.
When overhauling the brake caliper of the motorcycle
On 2018-05-22 16:08:12
This is sufficient when turning the piston when replacing the brake pad.
However, by just using the piston that went all the way in the overhaul
Because it was hard to pull out, pulling out with hydraulic pressure or air to some extent
It is easier to keep it.
I bought it for taking out the piston to make OH of the caliper of the bike.
On 2018-02-23 23:42:05
With this tool, none of the two pistons on the front caliper could be withdrawn. There should be little sticking. I'd like to fix the tool inside the piston and pull out grindingly, but I could not pull out the inside of the piston just with scratches and gouge. Although the idea of this tool is good, I thought using it if there is room for considerable improvement.
Bike caliper maintenance
On 2018-02-13 21:50:59
Bike calipers Used for prevention of sticking of pistons for maintenance. Workability up.
Brake maintenance for large motorcycles
On 2018-02-12 15:50:10
There is no special dissatisfaction with usability. I think that it was a good shopping.