The reviews are automatic translation.
Let's make it as the cover frame of the operation box of the printing machine
On 2018-03-24 22:27:20
It is perfect for the cover frame with a thickness of 1, 6 mm and the contour is refreshing
The finish looked great as well.
It is a level that can be fully used as a product.
We will use it as standard item.
Used for edge protection
On 2018-02-15 15:21:33
There is no problem with the product itself,
249 yen at 1 m
It will be 253.6 yen per meter at 1268 yen at 5 m and it will be expensive.
If you buy the same amount or more, we ask that you make it cheaper.
Used for installation of entrance light
On 2017-11-30 15:17:22
I was looking for rubber that sandwiched the receiving bracket for replacing the entrance light, where I knew the grooved rubber and purchased it, I was able to replace it exactly well.
It is used for rubber on the edge of a motorcycle tank.
On 2017-10-02 19:31:14
It was perfect size.
However, it became soft when gasoline was applied, so it seems necessary to be careful.
Car aero parts installation
On 2017-09-22 20:18:24
I used it for installing the rear diffuser of the Lancer Evolution.
Because there is no special item, it is exactly right for the edging of the part cut out.
However, the width of the groove was narrow and it became a form that it was inserted forcibly.
Although the thickness of the part is about 5 mm, since the groove of the rubber is only about 2 mm, it is good if there is a wide groove width.
Durability is still unknown.
On 2017-05-29 17:34:52
It was able to be used just right. I also would like to purchase it.
Private for replacing shock absorbers in hatch
On 2017-05-23 17:35:19
I would like to purchase again with the standard size hatched water returned size and perfectly.
Car Door Edge Guard
On 2016-09-20 22:21:35
It is attached firmly without both tapes. The thickness was perfect. It is slim and good feeling.
Mounting on a plastic plate
On 2016-07-27 14:17:48
It was so soft that it was mounted without problems.
Repair of helmet
On 2016-04-26 07:53:37
I used it as a substitute because the rubber part of the helmet used for the motorcycle deteriorated and dislocated. Because the material is rubber, the adhesive used is limited, but somehow it was able to be attached. I think work was easier if the width of the groove part was already several millimeters, but it is useless because it is different from the intended use. Using a 1 m thing, the remainder is several centimeters. There was no waste with just size.