The reviews are automatic translation.
For holding down rugs and plastic sheets of kitchen gardens
On 2019-06-16 13:30:29
We use for holding such as rug or plastic sheet of kitchen garden. It is cut to 25 cm, the tip is bent into a peg shape, and the tip is polished and used with a grinder. It doesn't rot, so it's good. I have already produced about 100 and used it.
For hollow compensation of tools
On 2019-03-16 09:58:56
I bought ainex TL-015 [special precision tool set of 32].
This driver handle is hollow and it is difficult to attach a bit.
If you turn it on, it slips down to the back, so you have to level it.
Therefore, I thought that I would cut an aluminum round bar into a suitable length to fill the hollow.
It went well, and even if it turned up, the aluminum rod was stuck and it didn't fall in the back, so the work efficiency increased.
Dare, speaking of the request, the round bar of aluminum does not need as much as 1000 mm, so most of it has left.
Well, I think it can be used for anything.
It would be appreciated if you could sell it in smaller units.
On 2019-02-21 15:05:12
I am very happy, I hope to ask again. . .
Auto three wheel back shot mirror stay
On 2019-02-21 05:24:00
The position of the rearview mirror of the auto three-wheeler I was riding recently was not good enough and rebuilt the stay. Cut to about 400mm, screw on one side, bend and complete mirror stay. The back is much easier to see.
Production of pointer
On 2019-01-24 16:56:59
I am an amateur but easy to work with.
Automotive mounting bracket
On 2019-01-08 14:51:30
We purchased 9 mm, but the size was 8.7 mm to 8.9 mm
If there is so much difference, you need to buy it again
It was used as a core rod of a bearing with an inner diameter of 12 mm.
On 2018-12-04 18:10:44
Packing was polite and likable.
It fits nicely into a bearing with an inner diameter of 12 mm.
Production of experimental equipment
On 2018-11-23 15:15:20
Because it was aluminum, I did not expect much strength, but when it was 1000 mm or so, I could not withstand my weight and it was distorted.
Parts of self-made controller
On 2018-11-08 22:27:53
I purchased φ10. It is easy to process hardness. Machine with lathes and machining, transform into superb parts you want.
Cut the material, drill it and use it.
On 2018-09-20 21:03:28
Because the material is aluminum, it is handy because it is easier to process and it is also strong against rust, and it is useful because it does not want to sell at the home center etc.