The reviews are automatic translation.
Thread rework
From Japan
On 2018-06-01 18:37:48
Adjusting minus screw was small, and it was hard to tighten.
In a tapping drill machine, 4 mm round rod was processed with M4 × 0.7 dies.
From Japan
On 2018-02-18 09:50:06
For the round bar, the screw threads for entry are crushed due to poor engagement.
Fabrication of screws for engine parts
From Japan
On 2017-02-13 16:51:50
Screwing was also very smooth. Another dice which had been from before had a sharpness and this dice felt comfortably. I would like to purchase it in the future as well.
Tap cutting
From Japan
On 2017-01-12 14:49:23
I did tapping of 4 bolts but I could spill the blade from the 3rd and could not tap out inside. I thought that I want a little more durability, but I wonder if this is cheap because it is cheap.
Threading of stainless steel round bar
From Japan
On 2016-08-13 08:29:59
I cut a stainless steel bar with a lathe and made a thread. It was M12 so I needed a lot of power but I am satisfied with the cleanliness.
Correction of screw on shaft
From Japan
On 2016-07-04 19:52:11
Bali is so terrible that it can not be used. I was struggling with measures just because the delivery date was approaching.
Thread cutting
From Japan
On 2016-05-31 18:05:23
Because correspondence was fast, it was very helpful. The sharpness was good compared to other dice
Vehicle maintenance
From Japan
On 2016-05-18 19:32:40
It is useful because it has ADJ mechanism on thread cutting.
Φ2 Make screws from brass rod
From Japan
On 2015-10-06 16:09:07
I am not an expert in this hand, so I can not evaluate accurately. I feel the same as the sharpness which I have used so far. Usage is for hobbies. Make double-sided screws from the φ2 brass rod with a hollow cutout.
Car maintenance
From Japan
On 2015-08-29 11:53:33
Purchased M11 x 1.25. Although it was a size which is not usually put in the home center, it is immediately stocked with inventory. It helped a lot by fixing the bolt growing on the part.