The reviews are automatic translation.
Milling of milling cutter
On 2018-05-10 15:14:32
I used it for the first time today, but using a 8 mm and 10 mm drill
We made 5 to 6 holes
Although machining by automatic feed, the nail of the chuck slipped, the automatic feed operation is in operation with the drill idling and the cutter breaks
Seizure has occurred with the mandrel and nail of the chuck
I could neither open nor close it.
Trasco and Yukiwa, and Monotaro in February of this year, tried purchasing three manufacturers at the same time but it was damaged quickly.
I use other manufacturer's products everyday, but I use it without problems.
Drilling through holes in the drilling machine,
On 2018-01-29 15:26:50
It will be two months after purchase, it seems that the tapered parts do not match, the chuck is dropped, it is dangerous, it is not currently used,
Used in NC milling machine
On 2017-03-17 19:11:18
Cost performance lost extra large spanner attachment
Drilling with a drilling machine
On 2016-09-06 16:31:25
The bearings became gorillory for about two weeks after I started using them. (Although it is not even bumping ...) The long front model of the knurling part is disappointing although it was durable comparable to the manufacturer's product.
Normally used for machining
On 2016-06-01 08:34:32
Since Albrecht got broken, I tried it for trial. I am satisfied enough that I can buy it below half of Albrecht.
On 2015-11-27 05:50:28
I use it attached to the Hitachi drilling board We firmly chew, so the end mill will not be shifted I think that I should have purchased it sooner
Used in small milling machine
On 2015-04-24 20:54:03
I purchased it with Arbor and assembled it, I felt good, I still do not use it for the product, but I think that it can be used a little though.