The reviews are automatic translation.
On 2018-06-17 19:50:09
The tip of the drill does not shift the position when deciding the pilot hole for equipment installation
On 2018-06-03 22:38:43
Purchase to pull out aluminum rivets. I can cut through with the feeling that the tip scrapes from the outer circumference like a normal drill.
Drilling to put tin on single pipe
On 2018-05-15 19:42:36
Drilling in 50 places, this was completed with one. Until then, I did 5 laps to ten holes.
I think there are no improvement points. I am very satisfied.
I carry it with hanging on a bit holder
On 2018-04-24 10:38:07
I carry it for preliminary hole at the time of work on site.
Even if you hang around the waist with the advantage of short circuit, I am saved without worry of hurting the surroundings.
Is it easy to use?
On 2018-04-23 14:45:56
I used it for aluminum drilling but it was a thin stain (1, 5 mm) but I felt like I was a little weak as well, so it was possible to use it without problems in a rough place.
Drilling in aluminum, PVC etc.
On 2018-01-27 18:21:13
You can cut well, without shaking the core. It is short because it is short even if it is put in a tool box.
It is a little dissatisfied that there is no size of 1 mm and 1.5 mm.
Drilling brass flat bar
On 2017-12-03 04:55:28
Because of the drilling of the part which does not enter with an ordinary drill blade, it is as short as possible
This was the shortest if you searched for a bit type drill blade, but it was cheap
I did not expect so much because it was not a specialized manufacturer of industrial drills.
Try drilling 6.5 mm on the electric dollar on hand and try it without pilot holes
I pierced comfortably like a lie to the brass flat bar t 6 mm.
Moreover, because the electric dollar body does not enter, it is through the L type adapter.
Although it was drilling with an unstable posture, penetration was completed without difficulty about 10 places.
I have not tried it with iron / stainless steel, but I was moved by the sharpness of sharpness.
I appreciate it as grade of home improvement, thank RELIFE.
Used for holes for equipment installation
On 2017-12-01 15:22:09
Please be careful not to come off as the drill part and holder part may come off.
Hardware installation, removal
On 2017-08-16 14:57:33
Because it is cheap, it can be disposable.
Why is there not a long?
Pilot hole processing, plate processing
On 2017-06-18 10:33:23
It shakes well with less shake. It is too small to get in the way of the tool box.