The reviews are automatic translation.
On 2019-06-21 09:50:08
The size of the 20BT is incomplete.
Although thin lines can be fixed, 20BT is enough, and it is difficult to keep it a little thicker and 30BT is easier to use. In that, 20 BT is shortened to the band ....
On 2019-06-21 09:43:42
Ultra-thin wires can also be fixed firmly and are easy to use. This series is useful because there are few black products.
Ceiling wiring in the office
On 2018-09-10 14:35:24
Used as a fixture for ceiling fixed wiring to reduce floor ground wirings. Although it is a small item, its usability was good. As an improvement point, I want you to give a breadth to the corresponding size of the cable. There are cases in which it is desired to fix two piles.
To fix wiring
On 2016-07-29 09:30:11
I hope I have more adhesive strength.
On 2015-03-05 11:45:18
Working efficiency overwhelmingly higher than mount base + binding band, high. I would like to order 500 pieces, so please lower the unit price.
On 2015-02-12 12:38:57
Moderate hold down condition is fine.
On 2015-01-07 17:08:46
It is a fix of what I commented on this product last time, I wrote that the adhesion is weak but what I found after trying it later seems to increase adhesion over time. I thought it was weak at the time of peeling off the sheet, but after several hours it is in a state that it can not be peeled off (when used on steel plate)
I thought that fixing the signal cable inside the board.
On 2014-12-31 19:55:33
I bought it with reference to the evaluation of another person, but it is disappointing, in fact, adhesion will weak and it will peel off. I tried metal surface and plastic surface, but it can be peeled off with light force even if it is strongly pressed. I think that the white side being used is weak, but this product can not be used as cable fixing material. I will contact MonotaRO once, but I think that it will be replied that it can not be done because it does not adhere. Please refer to other people.
Securing the cable to the back side of the sheet metal
On 2014-10-30 16:05:06
Use it where the sheet metal is thick and you can not break through the cable guide. It is convenient to consider where to turn the cable when prototyping the product. As the item description explains, double-sided tape is easy to peel off, and the tape sticks firmly, so there is no stress on work. I am satisfied.