The reviews are automatic translation.
M7 x 1.0, used to remove the knock pin of the Honda Cub's horizontal engine
On 2018-09-10 21:31:31
It is used for engine cylinders which are fixed by heat and rust
Even if you grab a knock pin with pliers, it will only be crushed, but M7 x 1.0 tap
It can be easily pulled out by screwing it. At the tool shop in the nation chain
The shop front stock is not available and the delivery time is about 10 days so it is the fastest.
Used for D-SUB terminal inch screw fixing type
On 2018-06-24 06:25:23
The D - SUB terminal has inch screw type of M2.6 and No.4 - 40, but since most of PC uses inch screw type, I purchased one.
* When making various D-SUB connectors by your own work, you need to check whether it is a milli screw or an inch screw.
Supplement: When assembling a self-made PC, it is necessary to distinguish between M3 and No. 6-32.
On 2018-06-20 16:31:25
I bought 12.5 mm drill and M 14 mm tap to destroy the thread of the M12 mm drain and recreate it to M 14 mm. It worked.
For rebuilding the screw hole
On 2018-04-25 16:28:26
Because it was necessary to use emergency, it arrived in the next morning and it was saved. I was concerned that it will take time because Unify's inch standard, but it was really helpful. Next time please also thank you.
Classic car parts production
On 2018-03-30 18:35:34
Recently, in the shop in the shop, it is very useful because it does not sell inch standard screws and thread cutting tools.
Threading the aluminum shift knob
On 2018-02-05 18:21:29
Since it is not in the home center, I bought it here.
Shipment is early and will be saved.
On 2017-10-02 11:53:04
I used it for correcting fine thread female thread that had screwed up. Despite its special size, it is inexpensive and it can be obtained, and correcting work also ends without problems. It was saved.
For car repair
On 2017-09-27 08:12:39
I saved a lot of pitch of this size because it is small.
To screw thread correction of exhaust temperature sensor fixed by rust of Mitsubishi car.
Tapping on aluminum
On 2017-09-08 18:04:37
M6X 0.5 is not handled quite well so it is useful. It is cheap, but it is enough. Although it moves the screw hole with remodeling of the astronomical telescope, there are many special dimensions in the niche field.
On 2017-07-03 21:32:24
Because it is not a product partner (internal jig), I chose by the amount, but there is no problem.
Although others have said,
I am worrying about storage place or storage method.
I do not have any problem if I purchase it with 3 pairs of taps.
In the past,
When purchasing other company products handled by Monotaro Inc. via a tool store,
With M10 or less, when you purchase 10, you came in a box of 10 bottles.
This box was quite handy and I could keep a set of undergrowth etc in a set.
Please handle this box that can be stored with the Monotaro brand.
So, this product is a set of 3 taps set
If you purchase it as a replacement product, storage method is not troubled.