The reviews are automatic translation.
Used as operating handle of tabletop drilling machine
On 2018-06-04 17:03:59
Because it is a small tabletop drilling machine, add enough for this size.
Replacing the leap lever
On 2017-10-17 21:50:37
The tip of the bounce lever was broken and replaced by deterioration.
I think that the material is normal and it is normal.
As machine cover cover
On 2017-06-30 16:04:10
Is this a strange tap pitch or tap is not cut to the end? Because it is useless because it does not fit in, it can only tighten about 5 mm.
Ball that cuts off the carpenter of the door
On 2016-12-19 14:23:08
One thing worn out, one more place was gone, so I stopped wearing something a bit larger. Because the material is PP, the slide is good and it feels good. The screw was hard, but this time it is OK because there is no worry that it will come off without screw lock.
Maintenance of tabletop drilling machine
On 2016-07-02 09:01:58
It is satisfactory to tighten the tightening torque and apply a metal core.
Used for handle knob of metal saw cutting machine
On 2016-01-13 13:30:04
The screw was quite hard. It is good because there is no worry of detachment, but I want you to loosen it a little more. It is safe because it is a gold screw. No complaints about Cospa.
On 2015-08-03 20:27:14
It was also tight through the gauge. It was also difficult to enter the screws, there was no tap of the M6, and it was not installed, unless it was caught firmly with pliers. Of course, the handrail was full of scratches.
Stretcher control lever
On 2015-07-03 13:12:03
It is easy to grasp easily. There is also outstanding for red and it is the best.