I used it to make a single cylinder bike. Since the length is enough, it is good to cut it and use it.
(Translated by machine.)

It was cheap, and the electrical resistance was 0.5 kΩ at 20 cm (measured by a tester). Next time I have to buy 2 meters. 1 meter was too short. If you think that 1 meter is left over because there are 3 including the ignition, you are wrong.
(Translated by machine.)

I am satisfied because the price is reasonable and this product can be used for all 4 cylinders.
(Translated by machine.)

The silicone cord that was replaced 20 years ago peeled off, and it was a big deal... so I chose this product with good cost performance.No problem.
(Translated by machine.)

It can be used without problems. Both price and quality are good.
(Translated by machine.)

After more than 20 years, I replaced it because the continuity seems suspicious due to repeated plug attachment and detachment. After all it seems that the genuine cable had bad ignition. It has been improved. It's better not to use yellow or red, which has nothing to do with performance, but to use black, which doesn't look like it.
(Translated by machine.)

It is supple and solid. It was long enough. I was impressed by the sudden improvement in my condition because it was a replacement of a bad part.
(Translated by machine.)

It can be used without any problem, but I think that 1m is just barely long for a 250cc 4-cylinder engine. It would be helpful if you could buy it at 1.5m.
(Translated by machine.)

It is recommended to replace it with a new one after a few years at a low price. There is a rubber odor that is common in foreign-made resin products. It is a moderately hard outer skin that is neither soft nor ticky.
(Translated by machine.)

The genuine cable was deteriorated, so I replaced it. It can be used without problems.
(Translated by machine.)