The reviews are automatic translation.
Maintenance of air conditioners
On 2018-07-07 16:42:03
45C and the material is hard, the surface polished state is good. Cut with a cana saw
It takes a while but I think that it can not be helped.
Used for keyway of gear and timing pulley
On 2018-06-24 06:55:52
Mr.Meister desktop lathe Compact 7 change gear set customized for others.
In Compact 7, the thread cutting pitch is
Mill thread: 0.5 / 0.7 / 0.75 / 0.8 / 1.0 / 1.25 mm
Inch screw: 12/20/22/28/32/36/38/40 mountain
Although it is supposed to be only possible,
Once calculated by an individual,
Mill thread: 0.4 / 0.45 / 0.6 / 0.9 / 1.5 / 2.0 / 3.0 / π (for worm gear) mm
Inch screw: 13/14/18/24/48 mountain others
You can do it. In case
However, one spur gear 20/40/45 tooth module 1 must be purchased and reworked.
(If you ask reworking separately to the manufacturer, it will be pretty expensive, so it is necessary to process with self-responsibility on the lathe.) * Reprocessing is not recommended by the manufacturer.
We expanded the shaft hole diameter by self-responsibility and attached a key groove with a sculpture sword.
In the future, I plan to bake the machine key so that an accurate and precise key groove can be put in it. (For polyacetal etc., limited to nonmetal.)
During machine maintenance
On 2018-03-07 13:38:03
It was inexpensive but it was able to be used without problems.
I also want to use it if I have the opportunity.
Used for parts processing in vice + parallel block
On 2017-12-02 22:30:57
Machine parts, there are taps and holes on the edge just as well. In that case, place it on the parallel block, and pinch it between the product and the vice claw and use it. Using around 5, 6 and 7, it is convenient to deal with most "troubled". The price is also cheap, very good.
As a key material
On 2017-03-24 16:10:56
Although it is used as a fixture, it has no problem.
During part fabrication
On 2017-03-17 14:49:55
I used it for the first time. It was cheap and the delivery was quick so it was saved.
On 2015-12-26 20:09:01
It is saved because it is instant delivery
On 2015-08-01 09:20:01
Purchased as jig material, I am satisfied
Pulley of agricultural machinery etc, fixation of shaft
On 2015-03-30 21:42:51
Since it is used mainly for remodeling etc., it cuts it to the necessary length and uses it, so if you purchase the size you often use it will be in time soon. I am happy that it is cheaper than anything.
I used it to stop the rotation of the rotating shaft of the walking grass mower.
On 2015-03-16 17:15:54
Since it is long, it was cut to the required length and used, the size I wanted was 4.0 mm x 5.0 mm. In fact, I bought two of 4.0 x 4.0 and 5.0 x 5.0 purchase, and in fact the repair was done using 4.0 x 4.0.