Buy more than* S$200* and get FREE SHIPPING
Due to the heavy typhoon attacked to Japan on Sep/4/2018,
Items will be shipped from Narita International Airport(NRT) or Chubu Centrair International Airport(NGO),
which normally should have been shipped from Kansai International Airport(KIX).
It may cause delay on shipment. Sorry to have kept you waiting and thank you very much for your understandings.

  • Metal saw
  • Metal saw
  • Metal saw

Metal saw SEC100x0.5

3.67 (6)
Package Qty.
Ship pack of
54.99 SGD
In stock
Now we ship to...
...see all
Item Feature
For cutting and grooving of materials
Inner Diameter (phi mm)
Number of Blades
Outer Diameter (phi mm)
Thickness (mm)
High speed steel (HSS)
Customer Reviews
5 star 2
4 star 1
3 star 2
2 star 1
1 star 0
Review Rating: 3.67
6 Customer Reviews
The reviews are automatic translation.
For metal cutting and splitting
From Japan
On 2018-09-01 15:22:29
It took a while to design and create the shaft, and finally I could test it. Since the shaft was made to correspond to the disc with inner diameter holes Φ 10, 15, 20, 25.4 mm, sharpness comparison of each manufacturer was possible. The cutting of iron (steel cans etc.) is a bit sharp in MonotaRO's metal saw. There is no problem in cutting of aluminum or brass · ABS resin block. Stainless steel is impossible unless it is a thin plate. It is 1mm thick. I tried cutting a 3 mm thick stainless steel plate slightly, but stopped cutting it in a few millimeters. When looking at the blade with the magnifying lens, the cutting edge started to roll. Let the number of revolutions slow to the extent that the metal saw is not burned, let the cutting speed slowly advance. Let's make it to the extent that it will make powder a powder. Otherwise it will not last long. Let's use cutting oil as much as possible. I think that it will become impossible to cut off immediately if you use it with the disc saw sense of chip saw. It is almost the same as the circular saw highs for mini router. It's just big.
This review is about item#7334643.
Slitting of aluminum parts
From Japan
On 2018-05-18 21:01:05
Although the depth of the groove is shallower than that of Japanese items, it is enough for aluminum use. It is okay to raise the cutting speed a little.
Cutting of plastic
From Japan
On 2017-03-11 00:24:26
A brand new sharpness is good. I hope you can keep the price a little more.
This review is about item#07334643.
Used as a clamsless circular saw
From Japan
On 2017-02-08 03:52:07
Attached to the disc grinder, the wood cut was beautifully cut. Thickness of 0.5 mm was better, but we made it 1.0 mm thick since it will be used for aluminum, brass and iron processing with milling machine · drilling machine. Satisfaction The reason why I did not make it to five stars was because I thought that a little more consideration was needed for packaging although I said on the phone.
This review is about item#07334643.
Slit machining
From Japan
On 2015-03-25 17:47:52
It was able to process without problems.
This review is about item#07334634.
Slitting aluminum round bar
From Japan
On 2014-02-25 20:06:17
Because the hole diameter is different from the metal saw which I had from before, I am reworking the arbor. It will be appreciated if you can line up smaller shaft hole diameters.
This review is about item#07334634.